Sentence examples for specifications specified by from inspiring English sources

Results from the aerosol concentration measurements show that the percentage deviations from the mean aerosol concentrations at any measurement point are less than 10% for three different wind speed levels, which meets the aerosol wind tunnel performance specifications specified by the U.S. Environmental Protection Agency EPAA).

For models which contact between components existed, mechanical specifications specified and connections and interactions specified as the following: Connections and interactions between bars and concrete by the technique of embedded elements.

This approach takes into consideration all behavior and side constraints specified by standard specifications for piles.

The number of downlink slots may vary in LTE networks according to switch point periodicity is specified by LTE specifications to cater the traffic load and provide some balance in traffic scheduling.

In the seismic design specified by Japanese Specifications of Highway Bridges (JSHB), a large gap size between two adjacent girders or the girder and abutment has recommended to be constructed in the concrete girder bridge with multi-spans in order to prevent the collision, when it is subjected to Level 2 ground motion.

The overhead of acquiring CSI is twice the minimum data rate and is approximately more than 20%% of the average transmission rate as specified by CDMA/HDR specification.

Then, it compared with the relationships with the serviceability region specified by the four specifications.

The PM10 inlet is characterized to meet the performance specifications for PM10 inlets, 10.0±0.5 µm, specified by the U.S. EPA.

The results of the finite element modelling showed, generally, that the design equations specified by the European specifications are conservative for the design of austenitic stainless steel plate girders of the maximum imperfection amplitude; hw/100.

The shear strengths of the hollow tubular flange plate girders are determined from the current finite element models and then compared to the unfactored design strengths computed according to Eurocode 3. It is found that the results of the design equations specified by the European specifications are highly conservative compared to the results of the finite element models.

Because specification-based slicing enables one to focus attention on only those program statements which realize the functional abstraction specified by the given specification, it can be widely used in many software engineering areas.