Specifically, maximum end-diastolic velocity of blood flow (MEDV), time-averaged maximum velocity of blood flow (TAMXV) and peak systolic velocity of blood flow (PSV) were evaluated.
Specifically, maximum conductivities of the transient-outward current (gtos and gtof), the sodium current (gNa), and the rapid (gKr) and slow (gKs) delayed-rectifier potassium currents within the Mahajan-Shiferaw model were varied to define distinct endocardial, midmyocardial, and epicardial regions.
Specifically, maximum-likelihood (ML) and Bayesian methods determine the probabilities of substitutions between orthologous sequences using different nucleotide/amino acid substitution models (Whelan and Goldman 1999; Anisimova et al. 2001; Yang et al. 2005).
Specifically, the maximum likelihood and linear maximum signal-to-noise ratio (SNR) estimators have been developed in flat fading channels in [9].
Specifically, the maximum specific α-amylase productivity was 18% and 3.5% higher than that of the experimental results and a simplified Markov chain Monte Carlo (MCMC) method, respectively.
Specifically, a maximum specific capacity of 190.3 mAh g−1 and ultrahigh rate performance with capacity retention of 96.1% from 1 to 10 A g−1 in a three-electrode test.
Specifically, the maximum difference approach required on average 1.25 less experiments than both the maximum entropy approach (P < 1.5 × 10 − 73 ) and the random approach (P < 5.1 × 10 − 71 ).
From the methodological point of view cardiac function was indirectly assessed by means of the first derivative of left ventricular pressure over time, more specifically, the maximum rate of isovolumic pressure development (+dP/dtmax, an inotropic index) and the maximum rate of isovolumic pressure decay (-dP/dtmax, a lusitropic index).
Specifically, the maximum methane adsorption capacity of the Triassic shale was 0.74 4.71 mL/g and averaged 1.56 mL/g, whereas the maximum methane adsorption capacity of Jurassic shale was 1.12 14.7 mL/g and averaged 4.82 mL/g.
More specifically, the maximum fundamental modal frequency is limited to about 2 MHz in immersion by the process design rule, and the maximum output pressure is restricted by a maximum driving voltage of 25Vpp because of potential dielectric breakdown of the piezoelectirc layer.
As Gareth Hatch, a contributor to ARPN's report on the matter, points out, "The problem with technology metals is that our supply of them or, more specifically, our maximum rates of production of them is critically dependent upon our production of base metals".
