Sentence examples for specific milling from inspiring English sources

With regard to the substrate, GaAs has a lower sputter yield than InP[25] which means that for a given ion beam current and voltage, the time required for a specific milling step will be higher.

The selection of specimens was conducted as follows: All specimens had an inner diameter of 46 mm - 48 mm and were milled to an inner diameter of 50 mm using the implant specific milling device.

Liu et al.  [13] characterized the energy consumption of machining parameters for a specific milling machine tool.

Hence, most of the empirical equations developed for describing the process of size reduction in specific milling equipment tend to have a limited use and are not easily transferable to other mills and with different feed materials.

Three general-purpose equipments with stirring, oscillating and turbulent motions were applied instead of the specific milling machine with high power to avoid much investment at such early development stage.

In a Hogwarts-worthy reading room on an upper floor of the university's Alderman Library one morning, students in Advanced Descriptive Bibliography were bent over books with tape measures and mini light sabers called Zelcos, scanning the pages for watermarks, lines and other clues that can potentially trace a given sheet back to a specific paper mold in a specific mill.

Good correlation has also been observed between the simulated specific breakage rates and the specific mill power, which is in agreement with the scale-up method proposed by Herbst and Fuerstenau.

The framework is implemented to estimate material specific properties using milling experimental data at various impeller speeds.

The particle size change during milling was highly correlated to the specific energy consumption of milling through the Rittinger's model (0.91 < R2 < 0.96).

In the dry ball milling operation, the specific breakage rate of particles has been found to vary significantly with the size distribution of the particulate material.

The specific energy requirement (EM) to milling raw material using an impact knife mill with 0.1 mm screen sizes for producing F0 fraction was 125.7 WhKg−1.