Sentence examples for span angle from inspiring English sources
"span angle" is not a proper or commonly used phrase in written English
If you are trying to refer to the measure of an arc or angle over a specific distance, you may use the phrase "measure of an arc" or "angle over a span". Example: The measure of the arc over a 3 foot span was calculated to be 10 degrees.
In this study, the optimization of the VG span angle and the VG transverse location (Ly) was investigated numerically along with a simplified conjugate-gradient method (SCGM).
A search for the optimum span angle and transverse location (Ly), ranging from 30° < θ < 60° and 2 mm < Ly < 20 mm, respectively, was performed.
The parametric study is carried out to discuss the effects of gradient index, geometrical properties such as span angle, facing layers thickness and axial length to mid radius ratio on the frequency behavior of the sandwich panel.
In addition, the effects of surface boundary conditions, gradient index, span angle, facing layers thickness and axial length to mid radius ratio on the behavior of the sandwich panel are studied.
Our findings show that the penetration depth, span angle and span expansion area of the transverse cavity jet are increased with the injection diameter, and that the kerosene droplets are more prone to breakup and atomization at the outlet of the combustor for the orifice diameter of 1.5 mm.
The manner in which the natural frequency and wavenumber content of such modes shift and split as functions of the number of blades and their span angle is discussed in the light of a companion perturbation analysis for rotationally periodic structures.
The spanning angle, which is the sum of two adjacent angles of the same finger, is used to differentiate the thumb from other fingers, since the thumb has the largest spanning angle.
Next we calculated the FI per neuron for a large family of cubic lattices L φ, ψ generated by three unitary basis vectors with spanning angles φ and ψ. Figure 4D displays tr J L φ, ψ for θ1 = θ2 = 1/4 and various φ and ψ.
A given iron frame can be wound for any one of several possible numbers of pole pairs by using coils that span an angle of approximately (360/p)°.
The trailing edge of the wing twisted slightly upward along its span, the angle of incidence decreasing from +2° at its root to -½° at its tip.
Results show that the penetration depth, span-wise angle and expansion area of the transverse cavity jet are all increased with the injection pressure.
