Sentence examples for source strength from from inspiring English sources

Determination of the contaminant source strength from mass exchange processes at the petroleum ground-water interface in shallow aquifer systems.

This simple site-specific temperature response function can be used for gap-filling CH4 flux data for improving the estimates of CH4 source strength from irrigated rice production.

The paper illustrates the possibilities and limitations of the use of inverse methods in the deduction of acoustic source strength from radiated field measurements.

In this case the observed OOA concentrations were used to optimize the SOA source strengths from lumped biogenic, anthropogenic, and biomass burning sources.

However the results of the inversion to estimate source strength Q from the concentration field suggest that the unwanted impact of the terrain is adequately compensated by representing detector light paths as curves, approximating their true height above ground.

The motor is characterised by a line of four monopoles on its axis, the complex source strengths for which are obtained from the measured anechoic sound field around the motor using an inverse method.

Although most of the resuspended particle mass from these activities was larger than 5 microm in diameter, the resuspension of PM2.5 and PM5 was substantial, with source strengths ranging from 0.03 to 0.5 mg min -1) for Pmin -1nd form 0.1 to 1.4 mg min(-1) for PM2.5

This paper reports on the application of an inverse Lagrangian technique that uses localized near-field (LNF) theory to calculate the source strength profile of isoprene from deciduous forest canopies.

Induced (non phase-locked) source strength was calculated by subtracting evoked strength from the total strength [ 30].

For the OCMF investigated in the present paper with the pores per inch (PPI) of 20 and the porosity of 97%, the noise control mechanism was to suppress the source strength of tonal noise generated from the periodic impeller tongue interaction rather than to absorb the broadband acoustic energy.

This paper describes a theoretical acoustical model to predict insertion loss and radiated sound pressure level, in which the source impedance is obtained from measurement (see the accompanying paper) and from which the source strength is estimated.