Sentence examples for solution dispersion from inspiring English sources

A homogeneous dispersion of multi-walled carbon nanotubes (MWCNTs) in syndiotactic polystyrene (sPS) is obtained by a simple solution dispersion procedure.

Polysulfone/organoclay nanocomposites were prepared via a solution dispersion technique, and were characterized by X-ray diffraction, transmission electron microscopy, stress strain measurements in elongation, and thermogravimetric analysis.

A series of organic soluble polymer clay nanocomposite (PCN) materials that consist of organic soluble polyimide (SPI) and layered montmorillonite (MMT) clay are successfully prepared by the solution dispersion technique.

Nevertheless, it is difficult to control the number of ZnO nanowires using this solution dispersion method.

In this study, for the first time, high-yield chain-like one-dimensional (1D) Co nanostructures without any impurity have been produced by means of a solution dispersion approach under permanent-magnet.

In the solution dispersion method, composites of MWCNTs and epoxy resin were fabricated by mixing the epoxy resin with nanotubes pre-dispersed in ethanol, followed by solvent evaporation afterward.

This paper describes a new technique for concurrently evaluating the mass-transfer-effective bubble coalescence frequency and specific interfacial area of mechanically agitated gas-aqueous electrolyte solution dispersions by the chemical method.

In the case of the alloys prepared by the former method, the addition of more than 4 at.% Al resulted in a two-phase microstructure consisting of disordered fcc Ni solid solution dispersions in the L12 matrix, while in the case of the alloys prepared by the latter method, the addition of 4 at.% Al retained the L12 single-phase microstructure.

The unobserved regimes are: (1) three-layer flow, and (2) aqueous-solution dispersion with an aqueous solution film.

In addition to aqueous solutions, dispersion of biosynthesized Au NPs in organic polar solvents such as dimethylsulfoxide (DMSO) and ethanol was studied.

The extruder head is made of a micro needle and a cartridge where liquids, solutions, dispersion polymers, pastes, hot melts or reactive oligomers are initially stored.