Sentence examples for solution channel from inspiring English sources
Cooling tubes are installed in the solution channel to take away the absorption heat.
Several cooling tubes are installed in the solution channel to take away the absorption heat swiftly.
The results clearly indicate that the aqueous solution channel thickness is the most significant design parameter that affects the absorber size compactness; the thinner the thickness of the solution channel, the higher the ratio (Am/Vnet).
It was observed that the absorption rate increased by a factor of 3 when the solution channel thickness was reduced from 2 mm to 0.5 mm.
Therefore to design a compact and efficient plate-and-frame membrane absorber with water as a refrigerant, an optimum value of 0.5 mm for the solution channel thickness is suggested and a solution inlet velocity of about 0.005 m/s is recommended to achieve high absorption rates with acceptable pressure drop along the solution channel.
Therefore the laminar flow and heat transfer in the solution channel are studied based on a unit cell containing the sandwiched domain outside the cooling tubes between two neighboring membranes.
The thickness of the interface wall between the solution and the cooling water, as well as the solution channels width should be also taken into account.
At the design stage of the membrane absorber, the parameters that can be optimised to maximise rqV are porosity, pore diameter, solution channels depth and membrane thickness.
The latter are composed of rapid recharge components through shafts and solution channels and diffuse matrix infiltration, generating a highly complex, spatially and temporally variable input signal.
The microreactor used comprised a baseplate with solution channels, a polydimethylsiloxane (PDMS) membrane and a top plate with 'donut' shaped clamps which, once gas filled, pressed down onto the solution plate trapping both solution and nanowire bundle.
In low-permeability reservoirs, which are dissected by a network of interconnected fractures, solution channels, and vugs, water and gas flooding have been found to be ineffective secondary recovery methods (Raza 1971).
