The phrase "snap lock" is a commonly used term and is grammatically correct in a sentence.
It is typically used to refer to a type of fastening mechanism that is commonly found on containers, bags, or other items. Example: "Can you please put the chips back in the bag and make sure to close the snap lock securely?".
Expect all parts to be refined, even the silky-smooth zipper and ceramic covered snap lock – clearly only the best.
The maxillary expander (Snap Lock Expander 10 mm. A167-1439, Forestadent, Pforzheim, Germany) used for all subjects was Haas-type expander banded to the upper second deciduous molars (Figure 1).
Then melt a cup of dark chocolate, scrape it into a snap lock bag, snip off one corner and have at it on the cake, followed by white chocolate, allowing the warm melted chocolate to slowly drip like your emotions down the sides of this ridiculously tall cake.
Whether a reused grocery bag, or a snap lock bag, you'll need these spare bags constantly for putting dirty bibs and clothes in, or a soiled diaper.
It can be stored in the fridge in a large jar with lid, or frozen in snap lock bags or in containers for easy portion use.
Hanging from the wings of the new bench is a padlock, following a Russian tradition in which newly married couples snap locks on bridges.
Sergeant Richard Morris told the Birmingham Mail: "Offenders have snapped the lock cylinder in two by applying force to the cylinder.
In searching the firehouse, the investigators snapped the lock on a locker and found at least one case of beer and several bottles of hard liquor inside, Fire Department officials said.
Exeter Chiefs have snapped up lock forward Aly Muldowney on a two-year-contract from Glasgow Warriors.
If your string is fairly thick and your locks snap onto it well, a locking point may not be necessary to hold it in place when shooting three fingers under, but it is wise to have one, as the fingers can still push up on the arrow when the angle changes during the draw.
A snap-lock mechanism consisting of a male (on the bottom half of the connector) and a female (on the base) interfaces was designed for assembling the connector to the base without using screws.
