Sentence examples for smallest corrosion from inspiring English sources

The sample anodized at 80 V presented the highest corrosion resistance by the smallest corrosion current density (1.4 nA cm−2) and the highest polarization resistance (37.4 MΩ cm2).

The Hf/Si3N4 multilayer coatings with 10 bilayers showed the best anticorrosion performance revealed by the lowest corrosion current density of 2.798 μA/cm2 in electrochemical system and the smallest corrosion area of 0.22% after 48 h salt spray test, respectively.

Moreover, the superhydrophobic surface showed much smaller corrosion current density, reduced 8868-fold from the bare Al 6061 substrate.

The SS316L fabricated using LENS is characterized by a relatively low value of corrosion current density, which translates into much smaller corrosion rates.

A large corrosion potential (−129 mV) and a small corrosion current density (≈2.2×10−6 A/clearlyearevealseals that the corrosion resistance of the Al0.5FeCoCrNiCu coating is superior to that of the coatings.

It is considered that corrugated bulkhead is a preferred structural solution, compared to the flat stiffened bulkhead, due to several advantages such as lower mass, easier maintenance and smaller corrosion problems.

It was observed that even for small corrosion levels, there was a significant influence on the ultimate bearing capacity of the slab.

Comparing with Zn coating, the deposited Zn Fe layer reveals 10% nobler corrosion potential, − 0.987 vs. − 0.897 VSCE, and two times smaller corrosion current density, 42.0 vs. 19.7 μA cm− 2.

The polarization curve measurement results showed that the plasma nitrided samples exhibited more positive corrosion potentials (Ecorr), smaller corrosion currents (Icorr), and evident passivation when compared with unnitrided chromium plating/substrate system.

Post-test fractographic analysis of the corroded specimens indicate that all of the critical cracks originated from small corrosion notches on the order of 10 200 μm in width, 10 120 μm in height and 2 100 μm in depth.

In the whole transpassive region the nano-crystalline coating has a smaller corrosion current density than the bulk steel, which indicates the transpassive dissolution rate is decreased by nano-crystallization.