Sentence examples for slurry processes from inspiring English sources

The efficiency of the proposed parallel method was presented through industrial slurry processes that used high-density polyethylene (HDPE).

The ductility of various coatings deposited by chemical vapor deposition, pack cementation and slurry processes on Fe- and Ni-based alloys was characterized by indentation at room temperature.

Results of experiments and modelling show a good agreement and thus the derived kinetic parameters can be used for the optimisation of batch slurry processes as well as of continuous fixed bed processes.

The purpose of the present study was to elucidate the nature of the hydrogenation active sites on unsupported molybdenum sulfide catalysts, aimed at the improvement of the catalysts for the slurry processes.

Satterfield and Huff[1] reported recently on significant mass transfer resistances in the FT slurry process.

All membranes produced low TFA (2.6 4.6 wt% at Iodine Value of 95) compared to the slurry process.

High-temperature calcination of the supported Pt/Pd powder, before the slurry process, can further reduce this variability.

Selected Ni-base alloys also were aluminized via chemical vapor deposition or a low-cost slurry process and the as-deposited chemistry and microstructure are shown.

The aim of this work is to explain the electrochemical behavior of tin-based hydrocarbon nanoparticulate composite electrodes, synthesized by means of a microwave plasma technique without any binder or slurry process.

Pouch-type 80 × 60 mm2 all-solid-state LiNi0·6Co0·2Mn0·2O2/graphite full-cells fabricated by the slurry process show high cell-based energy density (184 W h kg−1 and 432 W h L−1).

Nascent polyethylenes of the high density and linear low density types prepared by gas phase polymerization, together with a series of nascent high density polyethylenes prepared by the slurry process, have been examined by X-ray diffraction, inelastic neutron scattering and Raman spectroscopy.