Sentence examples for sludge density from inspiring English sources

"Too black means too high a sludge density level".

The production of a high sludge density characterises these processes, at a minimum of at least 25% weight in solids.

Sludge density is proportional to reactor performance, and alternatively sludge size is disproportional to sludge density.

Sludge density is another indicator of high activity reactor performance.

Previous research reports explained that packing patterns were responsible for pore volume and sludge density, and subsequently sludge density directly led to reactor performance.

According to the reports the sludge density 52 55% [ 88] showed the maximum reactor performance.

A series of relationships among packing density, sludge concentration, coordination number, nitrogen removal performance, and HRT were evaluated.

Depending on this packing pattern, the nitrogen removal performance could be illustrated by the sludge concentration and substrate load: (6) R = 0.527 C X q (1 − C X ρ   granule ) 25.0 (C X ρ   granule · SV ) 0.16 C 0.23, where q is specific activity of the sludge, ρ granule is the density of granular sludge, and SV is the sludge volume.

Compared to dry raw sewage sludge, the energy density of sewage sludge after torrefaction increases under certain conditions.

All these methods are very efficient and economical for the biodiesel wastewater cleaning, but they produce a large amount of low-density sludge (Suehara et al. 2005).

It was found that the introduction of electroplating sludge reduced the bulk density and compressive strength, and increased the mass loss, linear shrinkage, porosity ratio and water absorption.