Sentence examples for slag were obtained from inspiring English sources

The n′ value of 1.4 for each AAB mix containing partial or full replacement of fly ash with slag were obtained from a previous study by Kar et al. (2012b).

A copper slag was obtained from the former Anaconda smelter site, USA and characterized by SEM-EDS, XRD, TG-DTA and ICP-OES.

As far as the resistance to chloride penetration is concerned, k-values derived from strength tests were not applicable and specific k-values should be evaluated; values higher than 1 were calculated for fly ash and ground granulated blastfurnace slag, whilst values lower than 1 were obtained for ground limestone and natural pozzolan.

Similar results were obtained in the laboratory with slag columns.

In the case of slag hydration, however, the values for rate of hydration were obtained from a previous study by Kar et al. (2012b).

Best results were obtained for concrete prepared using 100% steel slag aggregates.

Workability retention of about 45 min with 15%and20%0% of slag content was obtained using a polycarboxylate based superplasticizer; compressive strength decreased with the increase in slag content, as occurs for vibrated concrete, although at later ages the differences were small.

The position of the phase interface and the slag surface is obtained by an adaptive grid algorithm.

A decrease in compressive strength with increase of slag content was obtained, but this decrease in compressive strength is less important at late ages (56 and 90 days after mixing).

The best preparation condition of steel slag particle electrodes is obtained via orthogonal and single factor experiments.

Alkali-activated slag (AAS) binder is obtained by a manufacturing process less energy-intensive than PC and involves lower greenhouse gasses emission.