Sentence examples for slabs with the highest from inspiring English sources
The physical model is applied to fit the temperature of tens of different radial slices, allowing us to constrain the combined emissivity and albedo, thermal relaxation time and anisotropy parameters of the ring slabs with the highest radial resolution achieved so far with CIRS.
BFRP reinforced ballastless track slabs had the highest insulating performance, while those with SFCB demonstrated the second highest performance.
The shallow termination depths of the low-velocity slab crust and the very low level of seismicity in the slab crust are consistent with the high-temperature conditions of this slab (Abers et al. 2013).
Figure 4(a) demonstrates that for slabs of equivalent thickness (since l* = 495 µm in all the slabs), the attenuation of the focal field is more severe for slabs with higher g which, accordingly, have a higher scattering coefficient µ s.
Thus, the reported method opens a promising route towards the fabrication of Si-based photonic slabs, with high flexibility and compatible with the current microelectronics industry.
Current design methods and code formulas for the assessment of the punching shear strength are normally based on tests on slabs with relatively high slenderness, i.e., with high shear-span to depth ratios.
Regardless of SRA and EA contents, the slabs with the lowest thickness of 40 mm showed shrinkage cracking at a very early age, while the slabs with higher thicknesses of 60 and 80 mm showed no cracking during testing.
Fill the slabs with the fertilizer plan.
The strain-hardening and multiple cracking behavior were observed for slabs with reinforcing indices higher than 316 whereas the softening behavior was observed for lesser values.
Enochsson et al. (2007) tested two-way slabs strengthened with CFRP and the results showed that the stiffness and ultimate load of the slabs with large opening is higher than the small opening with the same opening locations.
Although there is a systematic bias in our data probably because of the effect of the subducting slab with high seismic velocity, the epicenter deviation is generally smaller than 0.1°, provided the location is limited to the north of 39°N.
