Sentence examples for size of district from inspiring English sources

To ensure a range of opinions, researchers selected participants based upon their role in CPH management or PHC facility, size of district or facility and performance of district as informed by immunization indicators.

Whilst the largest district (twice the size of district 3) reached the largest number of schools (n = 540) and health facilities (n = 125) its overall coverage was at the lower end of the range (77% and 80% respectively) (Table 2).

In each district randomised to the intervention between 3 and 8 NPCs (the number depends on size of district but a minimum is 3 in one district with the overall total not exceeding 50).

Why not go in the opposite direction by doubling the size of districts to an even 1.5 million?

What's needed, then, is a significant increase in the size of the House by expanding the number, and shrinking the size, of districts.

"Whether a State is permitted to use some measure other than total population is an important and sensitive question that we can consider if and when we have before us a state districting plan that, unlike the current Texas plan, uses something other than total population as the basis for equalizing the size of districts," Alito wrote.

Whether a State is permitted to use some measure other than total population is an important and sensitive question that we can consider if and when we have before us a state districting plan that, unlike the current Texas plan, uses something other than total population as the basis for equalizing the size of districts.

Though statistical analysis cannot be done due to the small sample size of districts with turbines, a descriptive analysis shows some interesting patterns in Fig. 12. Figure 12 shows that districts with the most turbines had noticeably lower student-teacher ratios.

By removing representational duplication in two houses, the size of districts would be reduced to 300,000 from about 1 million each.

Results indicate that despite the large differences for individual buildings, a fixed infiltration rate model could be sufficient for early design studies of district energy systems, as the impact on the sizing of district energy systems remains relatively low.

The SimStadt platform currently permits the following analysis: solar potential and photovoltaics analysis, building heating demand prediction, simulation of long-term refurbishment scenarios, assessment of CO2 emissions, and automatic layout and sizing of district heating network (new or extension).