Sentence examples for size of additive from inspiring English sources

Since these vary across sires, an average value is presented to provide an indication of the relative size of additive genetic and residual variation.

Among small-effect QTLs, we focused on seven QTLs chosen on the basis of the size of additive effect and genomic position: these QTLs had additive effects of <3 days and their locations were different from those of heading date genes isolated previously.

In scenario 4, where the size of additive variance was maximum, the number of effects in the additive model was reduced to about the same as the number of QTL, while the number of effects in BSAM was still higher than twice the number of QTL because the allele substitution effects were expected to be nonzero for both breeds.

(2) Do the number and effect size of additive and epistatic QTL differ in two rhizobium genotype treatments (i.e. are QTL differentially detected depending on the rhizobium strain)? and (3) Does sequence level variation in known symbiosis genes have an effect on the ecological outcome of the symbiosis?

The market size of additive-free wine has been increasing.

The simple formula for the size distribution of additive sorption centres in polymers previously found experimentally is derived theoretically based on a two-component model of polymer structure.

We simulate the therapeutic effects as measured with additive scales in patient cohorts with different disease severity and assess the limitations of an effect size calculation of additive scales which are proven mathematically.

The results further revealed that the ratio of the atomic size of the additive element to that of Mo, which is the main constituent element in the C11b phase, is an important factor that controlled the misfit strain at the lamellar interface by the result of Cr addition.

Ghasemi et al. (2017) observed from their study that the size of the additives present in a mud system can influence the plastic viscosity and yielding point.

With the development of nanotechnology, the size of the additives can be reduced to a nanometer scale, and the reduced size can enhance the suspension performance, specific surface area, and heat transfer performance of the additives.

However, selection of type, concentration and size of nanomaterial additives that best fit the conditions for different purpose in drilling operations is still under investigation and needs deeper knowledge for different conditions.