Sentence examples for simulation only the from inspiring English sources
In the simulation, only the relays that correctly detect the active transmit antenna participate in the retransmission process.
Also, as one of the ways to improve the speed of the simulation, only the NMOS transistors, which suffer much more from the HCI effect, are considered in the modeling.
Parametrical experimental study highlights the stabilizing effect of internal pressure; in the simulation only the large displacement approach confirms the enhancement of the load capacity due to the pressurization.
In the simulation, only the symmetric channels are considered and the values of ω1kand ω2kare constant, i.e., the distance d1k= 0.5, ω1k= ω2k= c2 = 0.33, and ω0 = c2×(0.5) p. This leads to that the corresponding performance of the TWOR-AFNC-Nodir systems should be constant.
Apart from that, during the simulation, only the horizontal hole tapering is considered – whereas, in the fabrication process, tapering may also occur vertically - since the etching rate in each hole of the taper is different because the etching process is slower in small holes, as compared with bigger holes, and possibly results in tapering in the vertical direction, inside the hole.
In fact, after molecular dynamics simulation, only the C-terminal residues of this peptide have been subjected to conformational changes (Figure S3).
Of the steady-state simulations only the final 60% of the simulated data are used to ensure steady-state values are calculated.
In the Monte Carlo simulations, only the emitted alpha particles in the 211At decay were assumed to deposit energy in the target volume.
In the following simulations, only the decoding order based on the ascending channel gain is considered for WSR calculation in SC SIC.
To make a meaningful comparison, we did not include all the frame headers in our simulations, only the information related to the routing and the used transmission mechanism was focused on.
In the performed simulations, only the experimental parameters and physicochemical constants reported in the analyzed literature data were used.
