The simulated effective radius profiles were in better agreement with the observed profiles than those in the control run.
The curves are the simulated effective indices and the blue dots (TM0) and the red squares (TM1) are the measured values.
The simulated effective composite thermal conductivities are found to correlate very well with experimental measurements for a family of LWA-PCM composites considered in the paper.
Open image in new window Fig. 7 a f FE simulated effective plastic strain fields at crack initiation for the medium-strength material using one clamp (left panels) and two clamps (right panels).
One can estimate simulated effective λ z values as average vertical distances between inclined quasi-linear wave fronts in the lower parts of Figures 2a,b,c and 3a,b,c.
Although the difference between the observed and simulated effective height did not exceed 20 km, the regression was significantly affected by the fixed maximum height of the E layer in the IRI model.
Clearances, expressed as fractions of sheet thickness h, are indicated in each panel Open image in new window Fig. 8 a d FE simulated effective plastic strain fields at crack initiation for the high-strength material using one clamp (left panels) and two clamps (right panels).
In the present study, we simulated effective population sizes of Ne = 100, 1000, and 10,000.
Results of these analyses are summarized in Table S2, which shows generally excellent agreement between expected (analytical) and observed (simulated) effective sizes.
However, it appeared that with this simulated effective population size (Ne of 100), most of the LD is accounted for by 60,000 markers, and only a very small increase in accuracy was achieved when using sequence data.
