Sentence examples for side of the trough from inspiring English sources

The hair is always thicker on the other side of the trough.

Cyclists can take off into the fells, taking in several pubs, and end up at the Inn at Whitewell on the other side of the Trough of Bowland.

Because the large electron density gradient on either side of the trough affects radio wave propagation, the precise position of the trough is very important for many practical activities, such as trans-ionospheric communication and navigation.

Using the depth of the slope sediment beneath the offset deposits (1,000 m) at the landward side of the trough axis, the average deposition rate of the slope sediment can be estimated to be greater than 0.5 mm/year by dividing the sediment thickness (approximately 1,000 m) by the age of the accretionary prism (approximately 2 Ma).

Following the flow around the east side of the trough towards the north, poorly organized convection became associated with the persistent low.

The two main right lateral strike-slip fault strands that extend across the southern part of the trough are the Elsinore Fault Zone/Laguna Salada Fault to the western side of the trough and the Imperial Fault to the east.

T E and T P are the average TEC locations on the equatorward and poleward sides of the trough minimum, respectively.

After 20 minutes, the phospholipid film was compressed with two barriers at 3 compressionprateion rate until surface pressure reached 45 mN/m (compact LB films could be obtained at this surface pressure though it is smaller than the collapse surface pressure of the used phospholipid), and then the two barriers were released to the sides of the trough at the speed of 5 cm2/min.

The profiles for both Htz1 and Nap1 showed a low density at ~80 bp upstream of TSSs, corresponding to the NFR, and peaks at the two immediate sides of the trough that decrease to the background level (i.e. 0) at about 600 bp downstream of TSSs.

At the same time, the shortwave trough moved southward along the west side of the other trough.

The texture of the powder metal interface and the gap distance between the lid and side wall of the trough were varied, and the effects of shear rate, powder bed thickness, and consolidation times were tested.