Sentence examples for side inlet from inspiring English sources

CH4 is used as the working fuel forming a mixture with CO2 at the permeate side inlet.

A high flow rate ratio of the side inlet to the middle inlet facilitated a rapid bifurcation of the middle inlet solution to the sidewalls of the main channel51, 52.

Furthermore, effectiveness decreases about 1, 2, 3, 4.5 and 5.5%, respectively for the hot side inlet temperature of 400, 500, 600, 700 and 800 K.

Inlet phenomena in a 0.1 m diameter cold-flow riser with a 35∘ inclined side inlet are studied experimentally using 3D-Laser Doppler Anemometry for solids fluxes of 0.5 4.5kg/m2/s and gas velocities of 5.3 7.4 m/s.

For example, total annual cost increases 2.8, 6.1, 11.7, 15.9 and 19.9%, respectively for the hot side inlet temperature of 400, 500, 600, 700 and 800 K, and for the heat exchanger with effectiveness of 0.8.

The computational cases investigated are based on the design conditions of the HTHF, i.e., a maximum operating pressure of 3 MPa, hot and cold side inlet temperatures of 1173 K and 813 K, respectively, and mass flow rates varying from 10 to 80 kg/h.

A parallel-plate membrane contactor with side inlets and side outlets has been designed and used for air humidity control.

TPPS4∙2H2SO4∙4H2O aqueous solution (20 µM) was injected into the microchannel through the two side inlets at a flow rate of 30 mL h−1 for each side.

A solution of BTAC in N,N-dimethylformamide (DMF) and two individual DMF/H2O mixtures (v/v, 5/2) are injected into the microfluidic device through the middle and two side inlets (Supplementary Figs. 2 and 3).

Until relatively recently, barrier islands defended themselves against rising seas by, in a sense, moving to higher ground: Storms washed beach sand to the islands' inland side; inlets formed and healed, usually leaving sand deposits behind the islands.

Using the inclined microchannels, 61 mg mL−1 BTAC in DMF was infused through the middle inlet at 1 mL h−1 while a mixture of DMF/H2O (v/v, 5/2) was infused from the two side inlets at 30 mL h−1 for each side.