Sentence examples for shear control from inspiring English sources
Shear control ring (SCR) was suggested and determined to deconcentrate the shear stresses in the polyurethane insulation based on the finite element analysis [1].
The interpretation of these experimental data strongly supports the theory that bainite formation is promoted through a shear controlled type of mechanism.
Shear controlled orientation in injection moulding (SCORIM) is a non-conventional injection moulding technique that allows for the enhancement of the mechanical properties of semi-crystalline polymers.
The injection molded specimens of virgin iPP and the PET/iPP blends were prepared by conventional injection molding (CIM) and by shear controlled orientation injection molding (SCORIM), respectively.
Due to the up and down movement of the probe, both positive and negative shear is created, which is not possible with other shear controlled devices such as rotating cylinders, moving plates, and contractions.
The bars of neat iPP and PET/iPP microfibrillar blend were fabricated by shear controlled orientation injection molding (SCORIM), which exhibit the oriented crystalline structure (shish kebab), especially in the skin layer.
Wide angle X-ray diffraction has been used to investigate polymorphism in isotactic polypropylene (IPP) mouldings produced by conventional injection moulding and by shear controlled orientation injection moulding (SCORIM).
The largest difference in drift capacity of up to 100% is observed between monotonic and cyclic loading for shear controlled walls under double-fixed boundary conditions and low axial load ratios.
Multiwalled carbon nanotubes (CNTs) filled polymer composite based on polycarbonate (PC) and polyethylene (PE) was fabricated by shear controlled orientation in injection molding (dynamic samples) and conventional injection molding (static samples).
The flow was shear controlled at 8000 s-1 with a trans membrane pressure (TMP) of 0.5 bar.
The cells were allowed to adhere to the coverslip for ~10 min. No-shear control cells were then fixed on the coverslip with 1% paraformaldehyde for 1 h.
