Sentence examples for shaft relative from inspiring English sources

The experimental results show the effects on the discharge coefficient of rotational speed, flow rate, and co- and contra-rotations of the shaft relative to the discs.

Slipped capital femoral epiphysis (SCFE) is an adolescent disease that leads to retroversion of the femoral neck and shaft, relative to the head.

When being driven by ATP hydrolysis, the direction of the rotation of the central shaft relative to the immobilized F1 sector was observed to be counter-clockwise, viewed from the Fo-proximal side (Noji et al., 1997).

Typical applications are shafts where the shaft rotates relative to housing, but bearings can also be used to facilitate linear relative motion.

Due to the one-way clutch, the two shafts turn relative to each other only in the direction which increases wire tension, and thus it is possible to adjust tension of the wire by rotating one of the shafts.

The setscrew fits into a threaded hole in one member; when tightened, the cup-shaped point is pressed into a mating member (usually a shaft) and prevents relative motion.

The setscrew in the Figure fits into a threaded hole in one member; when tightened, the cup-shaped point is pressed into a mating member (usually a shaft) and prevents relative motion.

This chapter discusses that the purpose of a bearing is to support a load, typically applied to a shaft, while allowing relative motion between two elements of a machine.

The dynamically loaded spline shaft-hub connection that without macro relative movement between shaft and hub are exposed to the danger of fretting fatigue in the contact zone of teeth flank and plain fatigue at teeth fillet at the same time.

In contrast, non-aligned filopodia extend from the neurite shaft with an angle relative to the lines, scan the pattern using a lateral back and forth motion relative to the neurite shaft and then retract, the whole cycle being on the order of five to ten minutes (Fig. 4D, filopodia outlines by red and blue lines, angular motion quantified in Fig. 4E).

The inclination of the proximal humeral articular surface relative to the shaft (head shaft angle) is also variable, ranging from 30° to 55°.