Sentence examples for shaft load from inspiring English sources

To illustrate the importance of this study mine hoist load diagram is considered as shaft load of the tested machine.

Test results show that a system with 1 GB flash card can store over 10000 hrs of drive shaft load history data.

This paper details the development and potential of the drilled shaft load test (DSLT) database in which 351 case histories of static load tests from various countries can be freely retrieved and utilized worldwide.

The model is mainly designed to investigate blade and shaft loads due to both turbulence and waves.

The simulation results demonstrate that by increasing the installation depth of HAMCT from the free surface, shaft loads and power coefficient of the turbine experience oscillate respectively.

Finite element analysis (FEA) is employed to study the effects of nonlinearities on the accuracy of the analytical solution for the shaft loaded blister test.

Piping layout design is an area where the basic principles are frequently ignored, resulting in problems such as hydraulic instabilities in the impeller, which translate into additional shaft loading, higher vibration levels, and premature failure of the seal or bearings.

For these types of vessels, special attention has to be paid to the design of the stern region, the occurrence of a good flow towards the propeller and rudder being necessary to minimize fuel consumption and avoid excessive vibratory shaft loads and risk for cavitation erosion.

As Skudrzyk [4] has indicated that the mean point response of a curved casing can be treated as a flat plate under conditions which apply to gearbox casings, the representation referred to in this paper can be taken as typical of such examples as a gearbox casing excited by out-of-balance shaft loads or backlash, with concentrated masses or some degree of isolation added to the shaft housing area.

Stalin's decision that the Project 69 ships would use three shafts increased the shaft loading and reduced propulsive efficiency, although it did shorten the length of the armored citadel and thus overall displacement.

Using bulge and microelectromechanical system shaft-loading techniques, we evaluated the Young's modulus, residual stress and ultimate tensile stress of these films and laminates.