Sentence examples for settlement ratio from inspiring English sources

Additionally, it is found that the best and the optimal settlement ratio (S/B%) to design the piled raft as settlement reducer is 0.7%.

A catastrophic nature of water breakthrough was registered for a 0.6 m thick clay barrier with an overburden equal to that of a closure system of a low-level radioactive waste disposal site, once settlement ratio attains 0.6.

Using this method, the influence of embankment height, soft ground depth, soft ground elastic modulus, and geosynthetic tensile stiffness on efficiency, stress concentration ratio, settlement ratio, tension of geosynthetic, and axial strain of geosynthetic are investigated.

The variations of design limit parameters in the two modes of change to pier length and diameter including the applied load, top settlement, stiffness modulus and pier modulus, in terms of the slenderness ratio, make a linear function while the variations of load and settlement ratio show an exponential function.

What is healthy or normal depends on ethnic, social, age, and gender composition of a human subpopulation, the settlement ratio and the associated migration flows, climate and environment, living conditions and lifestyle, the technological level of health care and diagnostic procedures, anamnesis, and treatment history [ 135].

Choose the right type of coverage depending on these points Before buying health insurance, study about the claim settlement ratio of different companies.

Compression models are widely used in geotechnical and reservoir engineering for the prediction of settlement and void ratio.

The present study covers the characterization of soil, fly ash, compaction behavior, settlement, California bearing ratio, shear strength parameters (C and φ) and swelling characteristics, etc.

If those small wetlands (< 1 ha) could be fully mapped for pre-settlement wetlands, the loss ratio might be higher than the estimated 55.8%.

Based on the results of this investigation, design charts for use in estimating the maximum settlement and the stress concentration ratio during preliminary design are presented.

For Ulothrix (length: 5 8 mm), the surface also showed the best antifouling performance, the reduction ratio of the settlement on the surface with grooves spaced 12 μm apart could even reach 92%.