Sentence examples for setting a tolerance from inspiring English sources

In setting a tolerance level, the Food and Drug Administration reviews tests of the poison on laboratory animals and then establishes as the maximum level of contamination a quantity that is much less than that required to produce symptoms in the test animals.

By setting a tolerance level, the pseudo-inverse procedure will treat any singular value of the matrix that is less than the tolerance level as noise and set it to zero.

Therefore it is reasonable to suggest that setting a tolerance of 0 is just at the edge of the pathway structure distribution below which excessive amounts of noise pathways are extracted.

The set value of 0,15 (or 15%% given in percentage) has been selected due to the maximum possible error of the vehicle sensorial system measurements, which varies between 12 % 15%% (depending the measurements conditions and the road context), which sets a tolerance threshold.

The Environmental Protection Agency may soon move to set a tolerance, however.

FDA has not set a "tolerance level" for many of the drugs, pesticides and heavy metals found in beef, including copper and arsenic, which can promote growth and inhibit certain parasites.

The agency says to set a tolerance for a pesticide, it looks at studies submitted by pesticide companies to identify possible harmful effects the chemical could have on humans, the amount of the chemical likely to remain in or on food and other possible exposures to the same chemical.

For a fair comparison, we also set a tolerance of 0.2%, the same as when using BARON.

Instead of setting a small tolerance value ε, we can alternatively select a fixed number of sets of θ* corresponding to an acceptance percentage.

The setup of the insilico simulation involved the examination of the reported selected feature subsets when (a) applying a colinearity removal filter to the microarray dataset prior to the execution of the selection algorithm (marked as filtered/unfiltered), and (b) setting a 95% tolerance threshold to the best-obtained performance criterion (Tolerance/Best).

STEPS will not fail to run a simulation on a poor quality mesh, since setting an internal tolerance may be too restrictive, so users should decide whether to perform their own analysis on a mesh to determine if it is of acceptable quality before running a simulation.