Sentence examples for set of merge from inspiring English sources

The following probability is for a particular set of merge operations for x and y : (7) 0 merge: G → G′, with | V G |= k and | V G ′|= k + 1.

The following probability is for a particular set of merge operations for x and y: (7) The recurrence equation for a particular match graph G t) has the following form: (8) where the summation is over those match graphs that can be obtained by performing vertex split-and-merge operations on G t), and c j (μ, NM) are constants that depend on μ= μ1,…, μ L ) and NM.

Astronomers have measured a set of merging galaxies to determine the relative contributions to luminosity from star formation versus from accretion around the supermassive black hole nucleus.

These sequences were used to filter the corresponding reads from the full set of merged reads with NGen.

For both applications, we used a k-mer size of 100, 20 replicates, 10 cycles through the complete set of merged reads excluding all reads with any bases with quality scores less than 30.

Therefore, one can assume the flux at the smallest X2 (~0.25) to be close to zero and shift the entire set of merged pairs up by about six units to obtain the estimates of v3.

It looks as if the addition of the burglar alarm to the EWD configuration of security devices led to less rather than more protection from burglary with entry since 2001/02.18 Figure 7 shows whether the addition of an alarm increases or decreases security for two sets of merged CSEW sweeps, 1992 1996 and 2008/09 to 2011/12, across comparable security configurations.

To estimate transcript abundances for each transcriptome, we first generated sets of merged reads for each data set using PEAR (Table 1) (Zhang et al. 2014).

The spatial resolutions ratio of the data set for merging are required to be maximum of 1 6, where as the data sets (AWiFS and LISS-III) that are used in the current study are having the ratio of 1 2.5 approximately.

The problem of merging a set of queries can be formally described as: Input: A set of HiveQL queries Q={q1,...,q n }.Output: A set of merged HiveQL queries Q′={q 1 ′,...,q m ′ }, where m ≤n.

They load a set of reads and merge them until all reads in this set have been merged.