Sentence examples for sensitivity of the sample from inspiring English sources

Table 1 Image roughness and visual sensitivity of the sample images.

Therefore, the establishment of a standardized method that is simple, rapid, and has a high sensitivity of the sample purify is required.

Muthukrishnan et al. [9] used the sol gel dip coating method to obtain ZnO thin films and investigated the sensitivity of the sample to acetone, ethanol, and acetaldehyde.

Also, we investigate the issue of the sensitivity of the sample model to incorrect specification of the conditional expectations of the sample inclusion probabilities.

Peng et al. [8] also prepared 3D flower-like hierarchical ZnO nanostructure by the hydrothermal method and investigated the sensitivity of the sample to different gases and vapors such as acetone, hydrogen, acetic acid, ethanol, methanol, formaldehyde, and toluene.

Although the observed sensitivity of the sample is not found as good as expected, the overall performance of the system with respect to other sensing parameters (i.e., reproducibility, response, and recovery time) is found to be satisfactory.

The voltage sensitivity of the samples obtained from experimental measurement is compared with a simple model of sensitivity.

The average temperature sensitivity of the samples was found to be − 0.533%/°C and −(0.555 0.988)% °C− 1.

Prior to the Raman measurements, the sensitivity of the samples to the illumination was checked and no changes (either bleaching or darkening) were observed.

For further research on the thermal sensitivity and shock sensitivity of the samples, the Koenen test and UN gap test were conducted.

Luo et al. [10] employed a hydrothermal method to produce mesoporous ZnO and Sn-doped ZnO thin films and studied the sensitivity of the samples to different volatile vapors including ethanol, methanol, acetone, formaldehyde, and ammonia.