Sentence examples for sensitivity of the mode from inspiring English sources

In this paper the sensitivity of the mode shapes of two closely spaced eigenvalues are studied.

Closed form solutions are given for general combined mass and stiffness perturbations, and it is shown that there is a smooth transition from the case of moderate sensitivity of the mode shapes towards the case of repeated eigenvalues where the sensitivity goes to infinite.

Overall, the analysis of KIKO responses [which are restricted to the ERE-independent mode of ERα-dependent response (Jakacka et al. 2001; O'Brien et al. 2006)] to the endocrine-disrupting chemicals (BPA, HPTE) indicated similarity with the KIKO response to E2, confirming the sensitivity of this mode of ERα signaling for xenoestrogenic compounds.

The sensitivity for static mode increases with lower spring constant but the sensitivity of the dynamic mode increases with higher frequencies (higher spring constants).

The polarisation sensitivity of this mode is 25 for d top =d 2 and decreases with decreasing of d top.

The typical role played by the intermediate layer of AuNP on the effective index and thus on the sensitivity of the cladding mode to the surrounding RI has also been explored by carrying out coupled mode analysis of the requisite multilayer waveguide.

TeO2 film with a positive TCD not only compensates the temperature effect induced due to the negative TCD of ZnO(11¯20)/Si(1 0 0), but also enhances the sensitivity of the love mode device.

It was found that the Q-factor and the polarisation sensitivity of these modes are about 144 and 25, respectively, that is 3 times greater than for surface plasmon polariton exciting in similar structure without Bragg mirror.

Results are presented to demonstrate the sensitivity of the curvature modes with respect to the considered low damage levels.

The interaction of the spheroidal surface waves with the atmosphere also leads to high sensitivity of the spheroidal modes 0S27/0S29 and 0S34/0S37, whose frequencies are close to 3.69 and 4.35 mHz, respectively.

The value of λ k in the low-frequency range for specific arrays (e.g., linear arrays) will be proved to decrease with an increase in its order, which means that the error sensitivity of this mode-beam increases.