Sentence examples for segment thickness from inspiring English sources
An atomic chain is observed for thin nanowires with small twin segment thickness under tension strain.
The failure behavior is found to depend on the twin segment thickness and the diameter of the nanowires.
Lower uterine segment thickness measurement by ultrasound has been used to evaluate the quality of the uterine scar after cesarean delivery and is associated with the risk of uterine rupture.
Besides the obvious option of increasing segment thickness, an investigation is made into the technical and economic feasibility of double shell solutions as well as that of high performance or ultra-high performance concretes from the standpoints of structural engineering, TBM technology, process engineering, material technology and construction cost.
It is based on the definition of Figures Of Merits, consisting in numerical parameters, such as the ratio between the modules volume and the overall volume of segment assigned, the approximation between the real profile of the modules and the theoretical one, the form factor of the modules, the ratio between the module thickness at the mid-plane and the segment thickness at the same position.
J L is typically proportional to the light absorbed in the segment, which can be related to the segment thickness, δL, absorption coefficient, α, and the intensity of incident light, I 0, as shown in Eq. 2.
In grooved segments the maximum fat thickness was recorded, while in non-grooved segments thickness at three equally spaced points were averaged.
Segments of intestine were frozen in liquid nitrogen and cryosectioning (section thickness: 8 µm) was performed.
The purpose of this study was to establish the validity of sonographic evaluation of lower uterine segment (LUS) thickness for complete uterine rupture.
By adjusting the cross-sectional area and segment's thickness, the reduced current equaled the compatibility factor of the material at every local thermo-element layer.
Numerical simulations indicate smaller length of straight segment, smaller thickness and larger number of CF units are better for maximizing the off-axis/axial stiffness ratio.
