Sentence examples for sections are formed from inspiring English sources

Four sections are formed in the cascade, with the gradient around 300 200 m in the middle course and below 100 m in the lower course.

Therefore, a strength assignment obtained from a planar static analysis under a set of lateral loads simulating the aforesaid mode of vibration, represents a system in which all potential plastic hinges at the critical sections are formed at about the same time.

Examples include 454 pyrosequencing, based on the use of single primer-coated beads, combined with DNA amplification in which luciferase-generated light is emitted upon addition of individual nucleotides to the nascent DNA [ 1], and rolling circle replication, in which genomic DNA sections are formed into DNA nanoparticles (Complete Genomics / BGI-Shenzhen) [ 2].

In addition, the geometric imperfections of each member were measured before testing, as were the material properties of the cold-rolled sections and the virgin steel from which the sections were formed.

Prior to testing, the geometric imperfections of each member were measured, as were the material properties of the cold-rolled sections and the virgin steel from which the sections were formed.

Sections were formed with a poor subgrade (A-6) and two structural layers: the first section consisted of a base course and a surface built using a natural aggregate and a low quality mixed recycled aggregate, respectively, and the second section, which was used as a reference, consisted of a soft crushed limestone aggregate.

In that work, flat APB sections were formed with Ti4+ at the core, and the steps on APBs were always formed from four closely separated columns of Fe3+, which are linked together as edge-sharing FeO6 octahedra.

Through numerical analysis and insights obtained from the eigenfunction expansion of dyadic Green's functions, it is shown that evanescent standing-wave modes with complex cross-sections are formed within the cavity.

This powder was wetted up to 8 wt.% with water and pieces of rectangular section are formed by uniaxial pressing at 21 MPa.

Experiments are carried out in a setup in which two toroidal plasmas, each with an annular cross section, are formed around two flux cores (gray circles in Fig. 1a).

However, previous studies have shown that slots with triangle-shape cross section are formed, and extra processing has to be performed to remove the surface fluctuations, which degrade machining accuracy and lower total efficiency.