Sentence examples for section of the wire from inspiring English sources

Some people broke down a section of the wire barrier surrounding the pitch and set fire to benches and terraces.

After locating the NW with swift and low-dose scanning electron microscopy of 71 µC/cm2 (below the threshold to inhibit CE as previously shown31), one section of the wire is exposed to an electron beam at a high dose of 400 mC/cm2, which converts the ligands at the NW surface into a layer that is impermeable to cations31.

After FIB etching the root part of the wire and substrate, cross section of the wire root was characterized by SEM with sample holder rotated 45°.

From this point, to avoid a too high input current, it is necessary to have a small section of the wire [11]; moreover, if the section of the wire is too small, the thermal conductance decreases and the temperature of the wire tends to become excessive, leading to the melting of the wire.

Vickers microhardness tests of the non-immersed and immersed specimens were performed at room temperature from the surface to the center of the cross section of the wire at 0.05-mm 0.05-mmls.

The vertical height is measured from the mucogingival junction to the auxillary tube of the maxillary first molar tube (Figure 4a).This distance is marked from the superior surface of the 'u' loop to the vertical section of the wire (Figure 4b).

If the reduction per pass was too small, there were only a local deformation and the unfavourable stress-strain distribution could found in the transverse section of the wires.

With a variation of the modulus of elasticity of the wires, progressive stiffness of the archwires may be achieved without altering the cross section of the wires and have, as advantages, the use of rectangular wires in the first stages of treatment, guidance as to the choice or the wires, and less frequent changes [22].

As shown already in Ref. [12], the energies of all these interfaces are comparable, and the shape of 3 D nano-objects, from Wulff construction, should be rhombo-cubo-octahedral (the shape of the cross section of the wires should be a regular octagon).

They then grow and coalesce near the center of the radial cross-section of the wire.

On the other hand, another sample made by IGC-SuperPower® has copper stabilizer attached by electroplating, and the stabilizer layer surrounds the whole cross-section of the wire.