Sentence examples for section of the plate from inspiring English sources

The non-equilibrated tensile stress in the fractured section of the plate creates an elastic wave, which travels radially along the plate at the sound speed.

Using this approach the protein content of the original navy bean flour was increased from 25.4% to 47.0% in the final protein-enriched fraction collected from the bottom section of the plate in the separator.

Dr. Nestle praised the plate for being generally easy to understand, but she said that labeling a large section of the plate "protein" was confusing and unnecessary, because grains and dairy products also are important sources of protein and most Americans get far more protein than they need.

A series of calculation results showed that the total amount of injected or transmitted power flow is dependent on the natural vibration frequency of the whole structure and the relative percentage of power flowing through the cross section of the plate or the stiffener depends on the ratio of their relative flexural rigidity.

The plate was then bent so that the bend in the proximal section of the plate was reversed.

Fig. 6 (a) Vertical cross section of the plate subduction zone and the configuration of the model.

The number of colonies was counted for one or two selected plates (containing countable number of colonies), or from a section of the plates when very high number of colonies were obtained even for the lowest volume plated.

Dynamic stress concentration factors around the cavity and displacements in the cross-section of the plate are obtained near the cavity for various wave numbers.

The metric is found to be useful for determining which sections of the plate will produce energy based on curvature and deflection rate.

Particular attention is given to the case of heavy fluid loading, which occurs in underwater applications, when a substantial fraction of the energy extracted from the mean flow during the interaction can be expected to appear as bending waves propagating in both the coated and uncoated sections of the plate.

When using the mixture of calcium acetate and calcium chloride, oxides were observed at the cross-section of the plate and wrinkles were observed on the surface, indicating that the corrosion of the surface was less intense.