Sentence examples for section of the cable from inspiring English sources

More information about "Gen H" can be found on a section of the cable channel's Web site.

But because bedrock prevented crews from burying a 700-foot section of the cable deep enough to meet Connecticut's environmental standards, that state's officials blocked its use.

In a section of the cable titled Comment, it read: "Post will continue to push senior ROYG (Republic of Yemen Government) officials to increase security at all national atomic energy commission facilities and provide us with a detailed accounting of all radioactive materials in the country".

The parametric study also changes the values of the length of the span (L_{text{span}}), the sag of the cable (f), the cross section of the cable (a_{text{c}}) and finally the beam inertia (I_{z}).

The eight rows are each different to create one section of the cable pattern.

Because of particularly resistant bedrock, sections of the cable in New Haven Harbor could not be buried at the minimum depth required by permits, or 48 feet below sea level, said Rita Bowlby, a spokeswoman for Cross Sound Cable Company, which built the cable.

Secondly, several design parameters that influence the dynamic characteristic of the system, including pre-tension value in the cable, cross-section of the cable, cross-section and length of steel-bar are discussed in the chapter.

Under another section of the law, cable systems must provide individual blocking devices on request, and the majority said this was more respectful of individual choice and less burdensome on free expression.

Later, a 30-metre section of the first-generation cable will be replaced with a second-generation cable.

For this analysis the cross section (a_{text{c}}) of the cable varies from 0.1 to 0.4 m2, and the rest of the variables that were displayed in Table 1 remain constant through the entire parametric study.

Use an internal noise suppression choke Part No NC 101 If the noise interference is due to an unbalanced/faulty cable pair then the noise suppression choke should be installed between the unbalanced/faulty section of cable and the induction source (electric fence or power line).