Sentence examples for section leading to from inspiring English sources

The trail is in the shape of a lollipop with a three-mile section leading to a seven-mile loop.

It is demonstrated that there is a critical level of loading, exceeding which causes a catastrophic reduction in the neck cross section, leading to dendrite detachment.

The performance of LAES is actually limited both by the inefficiencies of liquefaction and discharge section leading to lower value of round trip efficiency compared to other energy storage solutions.

Drag reduction effectiveness was negatively affected by the increase in oil fraction in the test section leading to negative drag reduction when the oil is initially the continuous phase.

More specifically, the calculations show that different laws of piston motion at a fixed average piston velocity (i.e., fixed piston displacement and fixed compression time) and fixed compression ratio result in different evolution of mean pressure, temperature and velocity fields in the RCM test section leading to different ignition behavior.

The estimation of the oversampling factor and signal power is performed using the algorithm presented in this section, leading to and for this particular data measurement.

The resulting variational formulation is solved with a finite element discretization over the cross-section, leading to a set of Hamiltonian ordinary differential equations along the beam.

The capillary pressure causes liquid phase displacement from the high-porosity to the low-porosity region resulting in smaller/higher fraction of the liquid/gas flowing through the microreactor cross-section leading to channeling and thus to an increase/decrease of liquid/gas flow through the core area.

There are about 17 of these sections leading to the infamous "get up place".

Moreover, adding a second cut to the ordinary RBS connection distributed the strains over the two reduced sections, leading to 35 to 60% reduction in the equivalent plastic strain at the reduced sections, at 6% inter-story drift.

If cuttings carrying performance is poor and cuttings removal is not in time during the drilling of horizontal wells, drilling cuttings will accumulate in the lower sections, leading to backing pressure, BHA binding and even drill pipe sticking.