Sentence examples for section for figure from inspiring English sources

We found that as little as 4 pg/ml rat rFGF2 increased the percent of BrdU+ NPCs (reported in the text of the results section for Figure 9).

In Results section for Figure 4D: "Knocking down DTKR had no effect in the same neurons for which we observed phenotypes with sNPFR-RNAi.

In Results section for Figure 4B: "In a previous report, we observed modulation of DM1 when DTKR levels were knocked down in most ORNs (Ignell et al., 2009).

We fully agree with this point and have changed the conclusion sentence in the Results section for Figure 2 to state that the data are 'consistent with the hypothesis that MP may recruit BRM/SYD to target loci'.

In order to clarify this point, we have changed the wording in the Results section for Figure 4D and E (subsection "mSCT generation requires Ca2+ release from internal stores").

Clicking on conditions belonging to the same tissue but un-clicking the conditions belonging to other tissues, the system provides a tissue-specific SAGE tag sequence for the selected tissue (Figure 3) (detailed operations are described in the Results section for Figures 2 and 3).

This observation is consistent with the analysis in Section 5.2 for Figure 7. Figure 11 The available transmission amount vs. Time for one observation.

We have added in the Results section text for Figure 6: "Since Focal Adhesion Kinase (FAK) is critical for matrix-dependent survival (Frisch et al., 1996), we investigated if FAK were increased in cells targeted for death when extrusion was blocked.

Statistically significant differences between osteoblast subtypes were determined by scoring their fractional representation on comparable immuno-stained sections (for Figures 1 and 5, >600 osteoblasts from more than six rays compiled from at least three fish; for Figure 6, >400 osteoblasts from more than four rays collected from at least three animals).

Our heat maze thus consists of a large circular arena (18 cm in diameter) on top of a 5×5 array of Peltier elements (individual dimensions : 4×4 cm), heated to aversive levels (37°C) everywhere except at one "safe" zone (20°C; see Materials and Methods section for details; Figure 2A).

The sections used for Figure  2 were all taken from mature leaves (midway between the base and tip) of the indicated plant species, reacted with the primary and secondary antisera indicated, and captured using confocal imaging.