Following these interventions a second set of measurements were collected, inside and outside the ATCT building, which indicated a substantial improvement of the indoor air quality.
(ii) A second set of measurements are carried out in the short transverse section of the sheets to get information on the distribution and morphology of orientation clusters through the sheet thickness.
The reason for the apparent discrepancy lies in the smaller gauge volume used in the second set of measurements, which causes the evaluated residual stress values to be dominated by the microscopic (Type II + III) residual stress components.
The first set of measurements was obtained following the aortic anastomosis and the second set of measurements was made following completion of the coronary anastomosis.
The purpose of this second set of measurements was to determine the effects of the different atmospheres in the electronic transport parameters of these samples.
The second set of measurements, carried out two years later (in 2012), yielded lower ACC concentrations thus suggesting further crystallization of the ACC.
The second set of measurements are computed using the exact radar rainfall maps (Fig. 3) for eight snapshots, i.e., ({{mathbf {y}}_{t}}_{t=1}^{8}) whose dynamics are unknown.
The measurements were then repeated by the other operator, and the second set of measurements was compared with the first by means of measurement systems analysis (MSA) conducted using the t test for paired data.
In addition to this, and to further reduce the investigators ability to recall any measurements, the data collection protocol was staggered in the following way; subject 1 (first set of measurements), subject 2 (first set of measurements), subject 1 (second set of measurements), subject 2 (second set of measurements), etc.
