Sentence examples for scan switching from inspiring English sources

This improves the reproducibility of MS/MS scan switching by greatly increasing the NP concentration.

For a large but small-diameter graphs such as the Kronecker graph used in the Graph500, the hybrid BFS algorithm [2] (Fig.   3) that heuristically minimizes the number of edges to be scanned by switching between top-down and bottom-up, has been identified as very effective in significantly increasing the performance of BFS.

A scanning switch then selects data from each of the users in sequence to form a composite TDM signal consisting of the interleaved data signals.

During this task MR scanning was switched off and participants responded via a microphone incorporated in an MRI-compatible head set.

The results obtained confirm that the designed probes are suitable for projection imaging of biological media with the use of scanning method through switching of the right pairs of sending and receiving elementary transducers.

A twofold state skip (TFSS) logic is developed to achieve a low scan power by skipping long scan chains to reduce switching activities.

During an MR scan the switching of magnetic field gradients causes vibrations.

HMM scan was performed by switching off all the heuristic filters, collecting all the hits and calculating the score mean and standard deviation; after verification of the normality of the score distribution using Past [ 67] only those hits having a score greater than 3 standard deviation above the mean value were retained.

Note that for the experimentally measured value of A = 1, probabilities of switching from scanning to foraging and from foraging to scanning of a theoretical isolated sheep (or those of an individual that would not be under the social influence of conspecifics) correspond to kS and kF respectively.

The effect of concentration of the chloride ion, the switching potential, scans rate and pH on the electrochemical behavior of Sn Ni alloy is discussed.

After that, the user device starts scanning neighboring transmitters, by switching among all channels, to find the best one based on some criteria, such as RSS, resource availability, and others (steps 3 and 4).