Never leave the saw running in between cuts.
Usually in a well tuned saw, it will take no more than 4 or 5 pulls to get the saw running.
Keep the saw running full throttle throughout the cut, easing the throttle off only as you are about to exit the cut on the other side of the log.
They slalom, they jump, they balance on see-saws, run through tubes, over ramparts, under bars and burst through something that looks like a collapsed parachute.
Since last spring, between classes, on weekends and all summer long, 70 students have been hammering and sawing, running wires and installing solar panels, turning the plans for an 800-square-foot house set at the edge of a parking lot into reality.
When cutting make sure the saw is running at full speed, set the saw into the brick and allowed the saw to do the cutting (do not force it).
Handheld wet tile saws require you to hold the saw and run it along the length of the tile for cutting.
Hold the hand file, which is encased in the wood block, firmly against the side of the saw, and run it back and forth against the saw teeth.
He seems to have missed the more practical point that the saw also runs with less friction in the now wider slot.
When your saw is running at idle, the blade should not engage and turn.
