Sentence examples for satisfactory friction from inspiring English sources

The results show that the proposed mixture has good mechanical properties while retaining satisfactory friction resistance and permeability.

The combination of the Ti(C, N) layer with a-C layer increases the load and the wear resistance capacity of the composite films, which gives satisfactory friction performance in the pin-on-disk tests with a wear rate of 3.7 × 10− 10−m3/mN.

The Ti/C multi-layered DLC coating deposited at a substrate rotation speed of 5 rev./min depicted an amorphous structure with 2-nm periodic thicknesses, and gave satisfactory friction performance in the pin-on-disk tests with a wear rate of 1 3×10−17 m3/Nm and a friction coefficient of 0.09 0.1 against 100Cr6 steel and WC.

However, despite the vast amount of data in publication it is difficult to find satisfactory agreement (on friction factor and turbulence intensities for example) between investigations or to find data at very high Reynolds numbers where many industrial systems operate.

Among the four tested ceramics, ZrO2 was found to be the most promising material as it exhibited the mildest wear and a satisfactory level of friction.

To impart such a building with satisfactory seismic performance, a friction damping system can be used, which consists of dampers and a braced frame.

Friction has been studied as a branch of mechanics for many hundreds of years and its laws, as well as satisfactory methods of estimating the magnitude of friction, have been known for nearly two centuries.

High friction is needed for the satisfactory functioning of nuts and bolts, paper clips, and tongs, as well as in the familiar processes of walking, gripping objects manually, and building piles of sand or of apples.

This observation implies that copper powder is not strictly required as a component in the starting friction material to achieve anyway a satisfactory tribological behavior associated with a stable friction layer.

In both cases the calculated values of resonant frequency and internal friction are found to be in satisfactory agreement with experimental values.

The novel pretension technique showed a satisfactory performance throughout loading while high pretension levels could be achieved without friction between the external wrapping and the concrete column.