Sentence examples for samples with grain from inspiring English sources

Samples with grain sizes varying between 3 and 23 μm were prepared by altering the extrusion conditions.

Samples with grain sizes of 10 110 nm and densities of greater than 98% of theoretical were produced by inert-gas condensation and warm compaction.

Samples with grain sizes of 100, 150 and 290 nm have been tested at temperatures ranging from 25 to 500 °C.

Four sets of specimens with different initial microstructures were used, i.e. annealed samples with grain sizes of D0=15 and 2.2 μm, and dynamically recrystallised ones with D0=3.5 and 1.5 μm.

Total elongations of 1 4% were observed in samples with grain sizes less than 50 nm, while a sample with a grain size of 110 nm exhibited > 8% elongation, perhaps signifying a change in deformation mechanism with grain size.

Crystal plasticity finite element simulations of tensile tests on thin polycrystalline samples with grain orientations representative of the microstructure in Al Cu Li rolled sheets are carried out to study the influence of grain-to-grain interactions on plastic strain localization.

The leakage current density is large (> 100 μA/cm2) for the sample with grain size of 25 nm.

Polychromatic beam is best suited for polycrystalline sample with grain size larger than the beam size, while monochromatic beam is best suited for polycrystalline sample with grain size smaller than the beam size.

Furthermore, among all samples, the sample with grain size of 95 nm is found to have the smallest leakage current density (< 1 μA/cm2).

The inset in Figure 5 shows the magnetic hysteresis curve for the sample with grain size of 25 nm has been measure at 55 K.

As the grain size decreases, the value of T N shifts to the lower temperatures and is equal to 52 K for the sample with grain size of 25 nm.