Sentence examples for samples printed from inspiring English sources

For the samples printed with a hole, the diameter of the hole was 5 mm.

The cross sectional morphology of samples printed by using the free-hanging printing method were analyzed.

These bimodal blends lead to significant enhancements in the mechanical properties of samples printed in the transverse orientation.

For instance, the mechanical properties observed of samples printed orthogonal to the print bed (transverse) are significantly weaker than those printed parallel to the bed (longitudinal).

The compressive strength, toughness and tangent modulus of samples printed with a delay of 300 ms were observed to be higher than other samples.

With the addition of just 3 mol% of each LMW additive, increases in the maximum stress from 15%to100%0% are observed for samples printed in the transverse orientation.

Random vibration fatigue tests for a sample printed circuit board (PCB) assembly were performed to assess the fatigue life of BGA and TSSOP solder joints.

In contrast, we attempted the same repair approach with a flawed strip sample printed with a conventional thermoset 3D printing material, VeroClear (Stratasys, MN, USA) (see Supplementary Note 5 for details).

To repair the sample printed with a hole, we first filled the hole with the 3DPRT polymer solution, and then applied the UV (365 nm) irradiation for 10 min and thermal treatment at 180 °C for 4 h.

In addition, comparing Fig. 3e with Supplementary Fig. 5, it is noted that the sample printed with 3DPRT has inferior mechanical properties compared to the conventional 3D printable thermoset material (VeroClear), which limits the potential applications of the 3DPRT39.

However, the transmission electron micrograph of a type A sample printed in the paper shows particles separated much farther than this.