satin samples mounted on continuous card folded to form 16 leaves.
Reflected or transmitted terahertz (THz) waves are recorded from GFRP samples mounted on the x y linear motorized stage during the investigation.
Vacuum-dried samples mounted on a glass cover slip were used for imaging, and areas of 5 × 5 μm were scanned with resolution of less than 0.1 nm.
The CNT samples mounted on an inclined substrate with a slope of 5° were exposed to tiny water droplets (50 to 500 μm in diameter) generated from a nebulizer.
Briefly, the instrument used a Nd YAG laser beam (Surelite I-20; Continuum, Santa Clara, CA, USA; wavelength 1064 nm, repetition rate 10 Hz) for desorption of samples mounted on a stainless steel substrate.
A straightforward method to increase the projected side facet areas is to perform AFM measurements on samples mounted on tilted wedge-shaped sample holders, as shown schematically in Figure 1a.
Receptor autoradiography was performed on 20-μm-thick cryostat (Microm HM550, Thermo Fisher Scientific, Walldorf, Germany) sections of the tissue samples, mounted on microscopic slides and then stored at −20°C for at least 3 days to improve adhesion of the tissue to the slide.
XP spectra were collected from samples mounted on double sided adhesive tape with a Kratos Axis Ultra spectrometer operating with a monochromatic Al Kα X-ray anode (1486.69 eV) at 180 watts (15 kV, 12 mA), a hemispherical analyser in electrostatic mode (p <10−7 mbar) and charge neutralisation.
