Sentence examples for sample start to from inspiring English sources

In the region near the ultimate tensile strength, these micro defects in the middle of the sample start to grow and build up pores as for example shown in Fig. 12.

The sample starts to conduct at P ≈ 50 GPa.

The LiBH4/AC sample starts to release hydrogen from just 220 °C, which is 150 °C lower than the onset dehydrogenation temperature of bulk LiBH4.

The dehydrogenated Mg-Al-Ti-F-doped sample starts to take up hydrogen at room temperature with the 6.3 wt% amount of H2 at 150 °C, which is greatly superior to that of the pristine sample.

The arrow indicates that the sample starts to illuminate at around E = 2 kV/cm.

With more Zr doping such as 5%, the PL intensity of Zr/N-TiO2 sample started to increase again.

As the entire sample starts to loss its strength to support differential/shear stress, it is subjected to macro/bulk yield, and plastic deformation and/or viscous flow begins.

However, no primary preventive (initiation prevention) effect was found as in both groups 5.0% of the prospective sample started to smoke (table 3).

While during the low strain rate test true flow stresses between 2 and 2.3 GPa were achieved, the sample starts to plastically deform in the high strain rate test at ≍3.5 GPa and finally fails at stresses exceeding 4 GPa.

These hyperquenched samples start to relax, exothermically, far below the glass temperature, at a temperature (0.75Tg) where the thermal energy permits escape from the shallow traps in which the system becomes localized during hyperquenching.

For reflection above 600 nm, both 405°C and 438°C samples start to exhibit interference effects.