The implementation scheme of the 3D mechano-electrochemical model is shown in Figure 2. Firstly, to validate the model, the experimental test described in [ 33] with healthy cartilage sample parameters is reproduce computationally.
Some of the sample parameters are trivial, for example, "screen brightness," so no extra processing is needed for this parameter.
Sample parameters were considered to be significantly different throughout this study with P < 0.05.
Thereafter, a correlation of EC and TDS with examined water samples parameters is also evaluated.
Instead of randomly sampling all parameters, the estimated parameters values can be used and the number of sampled parameters is decreased, increasing the reliability of the analysis.
The following sampling parameters were used; sampling frequency 500 Hz, sample duration 15 sec., save period 5 min. The mean arterial signal was corrected for electronic offset, the average of one measurement outside the animal before and after implantation.
Essentially, overfitting is a consequence of having a large number of learnable parameters relative to training samples — parameters being those "neurons" that we were exhaustively adjusting via backpropagation in our previous article.
The optimization of the HS-SPME sampling parameters was carried out using fresh plant material based on the sum of the total peak areas obtained using GC-FID.
The optimization of the HS SPME sampling parameters was conducted using fresh plant material based on the sum of the total peak areas obtained using GC FID.
For each of the samples, parameters were measured, such as chloride, sulfate, bicarbonate, calcium, magnesium, hardness, sodium, nitrate and nitrite (mg/L), temperature (°C), and pH.
The selection of specific sampling parameters was justified on the basis of simultaneous measurements of the cortical morphology which demonstrate its influence on the appearance of the cortical layers.
