Sentence examples for sample formation from inspiring English sources

The intensity and spread (for the water vapor peaks) of these artifact IR active bands vary for the different samples, indicating different amounts of absorption during sample formation.

For the 14C content of the contemporaneous atmosphere at the time of sample formation, pmC T, measurements from the Black Forest station Schauinsland are used ([48] and pers. comm. I. Levin 2012).

Preparation method influences surface composition of the sample, formation of V5+ oxide being favoured with respect to V4+ oxide for the catalyst prepared in two steps, whereas a comparable fraction of VOPO4 is formed on both samples.

Open image in new window Fig. 2 Temperature versus pressure profiles of methane hydrate formation in pure water and O/W emulsions Table 2 Hydrate formation parameters for the O/W emulsion (3560 ppm oil) and pure water Test sample Formation pressure, MPa Formation temperature, K Pressure drop, MPa Pure water 10.03 285.27 0.93 O/W emulsion 10.72 283.96 0.63.

The research was performed in the following steps: (i) selection of the survey area and soil sample formation to be used in laboratory tests; (ii) characterisation of the selected soil sample; (iii) performing batch and Becker tests and (iv) final considerations on the applicability of soil flushing methods to the sampled soil.

Methodological quality of experimental studies (randomised controlled trial, clinical trials, controlled before and after studies) was assessed for sample formation, baseline differences between groups, unit of allocation to groups, measures of outcome and follow-up (Appendix A1).

High polydispersity of the samples, formation of intermolecular aggregations and branching are the problems more frequently invoked to explain the experimental results.

The result for the as-prepared sample shows formation of gold nanoparticles.

In this CuS/ZnIn2S4 sample, the formation of CuS (copper monosulfide) could be evidenced by XPS analysis results shown in Figure S5 (Additional file 1).

Melting curves of each amplified sample indicated formation of a single product in all cases.

However, the spontaneous aggregation simulations of the PHF6 peptides did not sample the formation of ordered, parallel dimers, which approached the respective crystalline reference state with a RMSD of less than 0.3 nm.