Sentence examples for sample discussed in from inspiring English sources

There is no universal surrogate measurement of digestion that can be used to accurately quantify digestion at the library preparation stage and no ideal control sample (discussed in Supplementary Information, Section S2).

11, 12 We have shown previously, in the sample discussed in this paper, that behavioural problems are found more frequently in children with PCHI than in hearing children. 2 We have also shown, in the same sample, that early confirmation of PCHI is followed by improved language (particularly receptive language) abilities at primary school age.

The two samples discussed in this report were grown by plasma-assisted molecular beam epitaxy (PAMBE).

The samples discussed in the following are fabricated using solid-source MBE.

From now on, all the samples discussed in this article were prepared with a negative potential applied to the substrate.

For the samples discussed in this paper, the available free energy is shown in Figure 7 based on the derived aS0 values.

Table 1 Thickness (measured by SE) of the as-grown and annealed samples discussed in this work Sample Number of ALD Al 2 O 3 cycles Thickness as-grown (nm) Thickness after RTA (nm) S1 0 8.2 8.6 S1 5 8.4 8.7 S1 10 8.8 9.0 S1 15 9.3 9.5.

Under identical annealing condition, the lattice constants of samples S1and S2 are different from each other, which reflect the different cation distribution in the samples (discussed in the next section).

(e_1 t)), (e_2 t)), and (e_{3}(t)) are the inputs to the linear network, which are considered known as they are quasi steady-state sinusoidal signals expressed in (13) with parameters estimated by using the input samples discussed in Section 3.1.

Figures 1, 2 and 3 show a subsample of river-cities and non-river-cities and their extractions (river-cut, river-high-cut, and non-river-high-cut samples discussed in the next sections) illustrating NACH and NAIN properties.

For all the samples discussed in this paper, we kept constant the gas mixture of 2.0% CH4, 98% H2 with 500 ppm of H2S, the combined flow of the gases to 100 sccm, the deposition pressure at 20 Torr, the filament temperature at ~2500 °C, and the filament-substrate distance to 8 mm.