Sentence examples for sample concentration of from inspiring English sources

The sample concentration of the "pre-mix" MBP sample was 600 μM and the HNCA was recorded in ~4 days with 16 scans using NUS to sample ~9% of a 75(15N)×750(13C) grid (5216 total sampled points).

A central composite face-centered design with 3 center points was performed in order to optimize conditions and to study the effect of four variables (pH of the sample, concentration of APDC, concentration of Triton-X-100, and sample volume).

The optimal conditions for the purification of G. lucidum crude polysaccharides with RFC were determined: sample concentration of 10 mg/ml, sample volume of 100 ml, sample flow-rate of 2 ml/min and elution flow-rate of 40 ml/min.

In this procedure, a series of sample in a closed 50 mL polyethylene test tube with solid sample concentration of 0.8 g L-1 was conditioned in a thermostatic shaker at 25°C.

The peaks of castanospermin and celgosivir were eluted early, retained in C18 column with high-concentration potassium buffer with sample concentration of 10 mg/mL, and they are less UV active in Fig. 1.

The limits of quantification (LOQ) for individual congeners were determined by a signal-to-noise ratio of 3 1 [based on Commission regulation (EU) No 252/2012] in the chromatogram or in case of analyte peak existing in the blank sample, concentration of the analyte in blank sample.

Sample concentrations of the experiments were 4 μM 15N-ITGA4, 4 μM CRT, and 800 μM ER-339093-13.

The SAXS data collected at sample concentrations of 0.8 4 mg ml−1 (FRP–L49E) or 0.55 5.1 mg ml−1 (oxFRPcc) showed concentration dependence above 2 mg ml−1 and, therefore, the data obtained at lower concentrations (1.7 mg ml−1 for FRPcc and 1.2 mg ml−1 for FRP L49E) were used for further analysis of the dimeric and monomeric forms of FRP, respectively.

Changes in sample concentrations of CO2 or organic acids cause potential instabilities when polymer membranes are directly applied to the surface of ion-selective field-effect transistors (ISFETs).

The QCM sensors (A, B and C) gave a good linearity against different sample concentrations of the 2,3,7,8-tetrachlorinated 2,3,7,8-tetrachlorinatedand a mixture of dioxins.

Except for a tube-well water sample, concentrations of the detected residues are above the acceptable limit for human body as assigned by different organizations.