Sentence examples for running torque from inspiring English sources
It takes very little torque to rotate the turntable once it is turning, he said, but it can take several times the running torque to start it.
It is shown here that a significant reduction in running torque could be achieved through proper design.
Squirrel cage induction motors, particularly the TEFC type (totally enclosed, fan cooled), have become extremely popular mainly because of their simple, rugged construction, and good starting and running torque characteristics.
The resultant voltage unbalance associated with open phase events can cause excessive heating in transformer core and coil assemblies and tanks, reduce the available starting and running torque of motors, increase motor acceleration time, cause inadvertent tripping of critical loads, and thermally damage plant equipment.
The starting friction torque of the bearing is about 1.76 μNm, and the running friction torque is less than 120 μNm when the bearing runs at a speed of 20,000 r/min.
With the simulation algorithm running in DCS, torque-controlled motor can mimic the aerodynamic and mechanical behavior of WTs.
Two optimum servo-amplifier settings were identified and the maximum sinusoidal dynamic torque capacity running unloaded (below 1400 r.p.m).
The modelled hydrogen engine has actually better than Diesel fuel efficiencies all over the load range and it also permits better full load power and torque outputs running about same stoichiometry.
Some authors proposed experimental procedures to determine the friction coefficient (Maidla and Wojtanowicz 1990) while other authors focused on modeling to allow the assessment of force and torque for running casing (Lagreca et al. 1997; Castelletto et al. 2010; Mirhaj et al. 2011).
But they are a wellspring to which conventional representative politics periodically turns for inspiration and momentum, when the conventional mechanisms run out of torque.
This allows the vehicle to run at maximum torque all the time, and could thus reduce fuel consumption by up to 30%, according to Peter Augustsson, the company's president.Even if the engine is optimised, however, the gearbox can still be a source of inefficiency.
