Sentence examples for rough mill from inspiring English sources

Rough mill the lumber is the next process.

Finally, the model was applied to ground and rough milled 4340 steel with satisfactory predictions of fatigue lives.

The results show that, at least in rough milling operations, internal CNC signals can double as an intelligent, sensorless control system.

The accelerate voltage of FIB was set to 30 kV, and the beam current was set to 0.79 nA for rough milling, which was then changed to 0.80 pA for the fine milling.

The angle between the electron- and ion beam was 52° and FIB milling was performed using a 30 kV Ga-ion beam with beam currents ranging from 0.44 to 7 nA during fine- and rough milling, respectively (Fig.  2a).

Milling artefacts such as curtaining were most pronounced on CNTLarge samples and were a result of either the rough milling surface with the protruding CNTs, or the difference in milling yields between the Epon and the CNTs.

Rough milling was performed with a rectangular pattern and 0.3 nA beam current, followed by sequentially lowered beam currents of 0.1 nA, 50 pA and 30 pA during the thinning and cleaning steps.

This paper proposes a new width control system composed of an RF (roll force) AWC (automatic width control) in the roughing mill and a FVM (finishing vertical mill) AWC in the finishing mill which aims at obtaining the desirable width margin in the hot strip mill.

The chips were dried to a constant weight at 65°C and rough-milled using a mill (Wiley mill; Thomas Scientific, Swedesboro, NJ, USA) with a 20-mesh screen.

Based on an appropriate gain, the developed technique enables to supervise the hot roughing rolling mill.

In this paper, an Active Fault Tolerant Control System dedicated to the speed control of a hot roughing rolling mill is designed.