Sentence examples for rotation towards from inspiring English sources
Regarding the X component, 'right torsional' indicates that the superior pole of the eyeball rotates towards the right ear and "left torsional" indicates rotation towards the left ear.
Mean range of rotation towards the most restricted side was 25° in the current study and 22° and 26° in previous reports [26, 31].
The simulation results showed that the shrinkage of grains with pure tilt boundaries was accompanied by their rotation towards higher misorientation angles.
Despite the channel die deformation mode used, a sample rotation towards the {4 4 11}〈11 11 8〉 orientation was observed.
The structure-based model presented incorporates the elastic straightening and stretching of fibrils, their rotation towards the tensile axis, and the viscous effects which occur in the matrix of the skin due to interfibrillar and interlamellar sliding.
These neurons increased discharge modulation during trunk-on-head rotation towards the recording side.
The crystallographic texture evolution is similar for both materials, being characterized by gradual crystallite rotations towards the stable end orientations typical of fcc metals.
The tiltmeters used to measure the rotations of the abutment were configured such that rotations towards the retained soil during the passive pressure cycle correspond to the rotations of negative magnitudes, and rotations away from the retained soil during the active pressure cycle correspond to positive magnitudes.
Trial-by-trial analysis was performed on consecutive vestibular stimuli in the 'on' direction for climbing fibers: ipsilateral vestibular stimuli (head rotations towards the side of recording) for VOR-increase training and contraversive vestibular stimuli (away from the side of recording) for VOR-decrease training.
Under buccal and lingual loading conditions, displacement involving rotation inclined towards the loaded side was exhibited; the displacements were substantially equal (Figure 8).
Each cycle is therefore built by the group of key-poses which, when summed, required the lowest amount of forced joint positions (i.e., the lowest amount of joint rotations set towards the centroid of their respective TGA distributions).
