Sentence examples for rotation configuration from inspiring English sources

The rotary SINS is an inertial navigator in which the IMU is installed on the rotational platform and rotated following the pre-designed rotation configuration, and the rotation error modulation is the technique that compensates the navigation errors caused by inertial sensor bias in a complete rotation cycle by rotating IMU.

C-mode brace end rotation configuration was found to be more unfavorable than S-mode configuration for the global stability of BRBs.

Non-wetting fluid ganglia are therefore subject to a maximum volume condition, defined by the zero-force geometry; for axisymmetric and periodically symmetric (i.e. symmetric by rotation) configurations this constitutes the zone of a sphere.

For the types of symmetry involving a single rotation, the configuration of landmarks can be divided into sectors, which are the repeated units.

(3) Rotation: the configurations are rotated around their centroids to minimize the sum of the squared distances between the corresponding landmarks and to optimize the superimposition.

The passage of hydrogen ions through the membrane causes the F0 portion and the stalk to rotate, and this rotation changes the configuration of the proteins in the F1 portion.

This study discusses the influence of screw configuration, rotation speed, and throughput on the residence time and specific mechanical energy (SME) and the resulting macroscopic CNT dispersion in polycaprolactone (PCL) based masterbatches containing 7.5 wt.% multi-walled carbon nanotubes (MWNT) using an intermeshing co-rotating twin-screw extruder Berstorff ZE25.

A 2D FE model corresponding to a slice through the operational plane of the cell was developed and used to investigate the influence of cell wall material and thickness, transducer configuration, rotation of a metallic stirrer blade and heat transfer fluid on the cell acoustic response.

The influence of the diffusivity and differential rotation on the configurations of the dominant modes are also presented.

This paper proposes an original method to determine the oil mist impingement over an insert based on different machining configurations (rotation velocities) and different inner canalization designs, without material removal, on milling tool.

A single nonenhanced continuous spiral multislice CT scan was performed (120 kVp tube voltage, 100 mAs effective tube current, 16 × 1.5-mm detector configuration, gantry rotation time 420 ms, 30-mm table feed per rotation).